Special Selling below cost as somehow I ordered 10 times more than we required my loss your win
Needle threader kits with the o-rings. TW-PK477
In Gold Or Chrome
Having trouble getting the thread though the eensy-weensy eye of that needle?
Not to worry—a needle threader makes the task easy.
These complement our Seam Ripper kits and look great in a set.
Seam Ripper kits and Needle Threader Assembly Instructions
Required Accessories
• 7mm, Pen Mandrel
• 8mm Drill Bit TW-DB008
• 8mm Barrel Trimmer
• 2 pcs Bushings Set TW-PK91#-BU $4.00
• Glue (Thick CA ) Em-2000
Preparing the Blank
• Prepare and cut a blank of 3/4” or larger, to the length of the brass tube (add
1/16” for trimming)
• Drill a 8mm hole through the center of the blank.
• Spread glue over the tube, insert into blank with a twisting motion to spread
the glue evenly inside.
• Center the tube inside the blank.
• When glue is dry. Trim the ends of the blank flush to the tube.
Turning the Blank
• Place the bushings and blank on the mandrel according to Diagram
• Thread on the knurled nut and hand tighten to hold all items in place.
• Slide the tailstock to the mandrel shaft, (do not overtighten, it could damage
the mandrel) lock in place.
• Turn the handle ends down, flush with the bushings using the lathe tools,
gradually increasing the grades of sand paper.
• Finish the wood with Shella wax friction polish .
• When not in use, reverse the ripper assembly to safely store the cutter or threader