Seam Ripper Kits 2 Piece 1 x stiletto /Owl 1 x Pick un pick 1 x pen clip cap
Either put together with the clip supplied or leave the clip off and fit together using both the Seam ripper and Stiletto
Available in Gold plating. With o-rings to hold the ripper in place. No sticker, no spring, new style!
Available in Chrome plating. With o-rings to hold the ripper in place. No sticker, no spring, new style!
Required Accessories
• 7mm, Pen Mandrel
• 8mm Drill Bit TW-DB008 Brad Point Drill Bit 8mm
•8mm Barrel Trimmer TW-PM012 Pen Mill 6 Cutter Head Set
• 2 pcs Bushings Set TW-PK91#-BU Seam ripper kit bushes
• Glue (Thick CA or Epoxy)
Instructions
• Prepare and cut a blank of 3/4” or larger, to the length of the brass tube (add 1/16” for trimming)
• Drill a 8mm hole through the centre of the blank.
• Spread glue over the tube, insert into blank with a twisting motion to spread the glue evenly inside.
• Centre the tube inside the blank.
• When glue is dry. Trim the ends of the blank flush to the tube. Turning the Blank
• Place the bushings and blank on the mandrel
• Thread on the knurled nut and hand tighten to hold all items in place.
• Slide the tailstock to the mandrel shaft, (do not overtighten, it could damage the mandrel) lock in place.
• Turn the handle ends down, flush with the bushings using the lathe tools, gradually increasing the grades of sand paper.
Finish the wood with friction polish.
Assembly
• Press the clip to one end of the tube.
• Slide the seam ripper assembly in and out with both ends to assure a secure fit.
• When not in use, reverse the ripper assembly to safely store the blade(s).