The go to tools for any woodturner for bowl turning are a 35 degree and 55 degree bowl gouge
Buy either in singles or as a pair ( I will re-sharpen one chisel to 55 degrees)
Introducing Carbatec's Next Level Woodturning Series!
Cryogenic treatment of M2 HSS means this steel has been subjected to a complex immersion procedure at temperatures as low as minus 195C. Sounds fancy (and cold!) but what does this mean? This treatment actually changes the structure of the steel, producing an ultra-fine and hard martensitic structure, supported by fine carbides.
Erm, yes... And in plain terms? Additional wear resistance and edge holding capability of approximately 2 to 3 times that of regular M2 HSS !! Now that's an impressive edge!
This is a 12mm bowl gouge. This means that the shaft is 12mm in diameter. Tip to tip on the flute is about 8mm
The blade is laser etched and 215mm in length,
The handle is also laser etched and is approximately 310mm in length.
May need final sharpening before use.
Incredible value for the quality.
Enjoy!