Mini Series Easy Tools less
300mm handles and 100mm x 10mm square Shaft 400mm overall
Choose Mini Series Tools if you use a mini lathe and do pen work or small goblets and bowls. Reach trough 30mm holes to hollow up to 50mm deep.
5200 Mini Easy Rougher $175.00 Now $131.50
Cutter replacement Ci2 SQ
6200 Mini Easy Finisher $175.00 Now $131.50
Cutter replacement Ci2
7200 Mini Easy Detailer $177.00 now $131.50
Cutter replacement Ci4
Which Easy Wood Tool should I buy?With a little practice and imagination, each tool will make your turning experience easier and more enjoyable by being used in a variety of ways. Here are some general guidelines:Easy Rougher tools, with their square carbide cutters, are designed for the primary purpose of efficiently removing the bulk of material on most any project – roughing cuts. Use an R2 cutter for final cuts outside curves on bowls and spindle work too.Easy Finisher tools, with round carbide cutters, were designed for the primary purpose of light finishing cuts; especially on the inside curves of bowls and spindles. You can certainly use your Easy Finisher for your bulk material removal and shaping too. Easy Detailer tools, with diamond shaped carbide cutters, were designed for the primary purpose of putting the final details on your project such as small beads and coves on both spindles and bowls. Very handy for cutting chuck tenons and making inside reverse angle cuts for inside chucking on bowls with dovetail jaws. This tool series can be used for roughing and finishing but they excel at the lighter detail cuts.
Buy the 3 set of Mini Easy Tools and we will ship for the $8.80 cost of a single chisel
Over seas orders quoted The above shipping does not apply