The 3/8” Square Shank Hercules is a smaller version 5/8” Square Shank Hercules tool The smaller 3/8″ Square Shank Hercules is intended to be used on smaller and more delicate turnings like pens, bottle stoppers and boxes. This tool is also a great tool for the acrylics.
The Hercules Tools have a 45 degree flat milled on the lower shaft which helps guide the turner for the bevel rubbing finish cuts.
The shaft length on this tool is 4” from the handle. The handled tool comes with a 12” handle which is the recommended length if you choose to make your own handle. The shank is a 3/8” turned round shank.
Please see the following link to see the tool in cut: Hunter Tool Demonstrations
The 3/8” Square Shank Hercules uses the # 1 components. They are # 1 Cutter, # 1 Screw, and # 1 Wrench.
I deal for hollowing rigs
The Hercules Tool was designed for the first cuts on a new piece. Let this hard working 5/8” Shank Hercules takes all of the shock and interruption. The 5/8″ shank is a strong shank and any impacts are absorbed by the shank and then distributed into the tool rest and down into the ways of the lathe. This tool can also perform with a “soft touch” for those final finish cuts. The Hercules Tools have a 45 degree flat milled on the lower shaft which helps guide the turner for the bevel rubbing finish cuts.
The shaft length on this tool is 6” from the handle. The handled tool comes with a 17” handle which is the recommended length if you choose to make your own handle. The shank is a 5/8” turned round shank.
Please see the following link to see the tool in cut: https://huntertoolsystems.com/hunter-tool-demonstrations-2/
The 5/8” Square Shank Hercules uses the # 3 components. They are # 3 Cutters, # 3 Screw, and # 3 Wrench.
Shipping overseas please email for a quote as post amount listed is for New Zealand only