Pro-mount detailing stand with Spindle Adapter(chose thread below) and tool post to fit lathe banjo
Post sizes below Spindle threads below email us your selection
Table mount and carvers plate sold separately
Postage listed for New Zealand only
Chuck not included
Tool post 5/8"x 3 1/4" (85mm) long |
Tool post 3/4”x 3 1/4" (80mm) long |
Tool post 20x110mm long |
Tool post 7/8”x 4 1/4" (110mm) long |
Tool post 1” x 5" (127mm) long |
Tool post 1” x 6" (150mm) long |
Tool post 1”x 3 1/4" (85mm) long |
Tool post 25mm x 110mm long |
Tool post 1 1/8’ x 6" (150mm) long |
Tool post 30mm x 135mm long |
Tool post 30mm x 150mm long |
Tool post 30mm x 180mm long |
Tool post 1 1/4”x 7" (180mm) long |
Tool post 40mm x 180mm long |
Spindle threads
1" x 8 tpi PMSD
1" x 10 tpi PMSG
1 1/4" x 8 tpi PMSL
1 1/2" x 6 tpi PMSP
30mm x 3.5 PMSQ
3/4" x 16 tpi PMSR
33.5mm x 3.5
Woodcut Pro-Mount Product description:
Enables a chuck or faceplate to be held in the best position needed for carving and texturing
• Full 360° horizontal rotation
• Full 360° vertical rotation
• M33 x 3.5mm spindle thread, for mounting woodturning chuck
• Ideal for embellishing and decorating a turned bowl
• Hollow spindle with 1/4" BSP thread for vacuum chuck
• Optional 85mm Carver’s plate and Bench stand that enables mounting on a cross slide or pillar drill are available
The Pro Mount enables a chuck or faceplate to be held in the best position needed for carving and texturing.
This sturdy and versatile product has two independent locking levers. The outer lever controls horizontal rotation, allowing you to turn the work through a full 360°. The inner handle controls vertical rotation through 360°. There is a great advantage in being able to adjust the work in one plane at a time. With the handles tightened, the workpiece will not move and carving or decorating can commence.
A range of Spindle sizes are available to fit the most popular lathes. The turner can mount a woodturning chuck with the same thread onto the Pro-Mount. Turners can screw a freshly turned bowl directly onto the Pro-Mount for embellishment and decoration while the bowl is held in the jaws of the chuck. The Pro-Mount spindle has a hole through the centre and a 1/4" BSP thread at its base for an airline fitting. This gives the option of using a vacuum chuck as a means of work holding. If you own the Woodcut Bowlsaver, the post from it fits the Pro-Mount, offering the choice of mounting the Pro-Mount on your lathe’s banjo.
Also available as optional is a Bench Stand with slots in the base to enable mounting to your work stand or bench and 85 mm diameter Carvers Plate with multiple holes and slots to fasten the work piece with screws is also available.