Woodcut 19mm Bowl Gouge Replacement Tip BT19

To replace a worn out gouge tip, heat the section around the joint with a blow torch for about a minute. This turns the Loctite glue to powder and the old tip can be easily removed, in fact sometimes during the heating process the pops off without any help. Once the shaft has cooled, clean the spigot and flange with a wire brush to remove any glue residue and then with the Loctite ® supplied with the replacement tip fix it to the shaft and leave to stand for at least a couple of hours, preferably overnight and if possible stand it upright.

Overseas by quotation.