Loading... Please wait...

Categories

Our Newsletter


Sort by:

WoodCut Bowl saver

Producing several bowls from a single block of wood is safe and easy with the bowl saver from Wood-cut.You get predictable result every time along with the security of knowing the saver is coupled to both the tool rest and the tailstock.

Every unit comes with a cd video outlining each step of its use.

Bowl saver Capabilities
The Woodcut Bowl saver couples to the lathe tool post and is also supported by a Morse taper that fits into the tailstock of the lathe.
The bowl saver will fit almost all lathes large and small, simply order a tool post to suit the lathe you are using.

Capacity: The Bowl saver uses two blades to give a combination of cuts that will remove blanks from 75mm93”0up to 300mm (12”) from the inside of the mother bowl (outer bowl).
The depth that the blades will go into the wood can be adjusted from zero up to 130mm (5”).
This in essence will remove a bowl 300mm (12”) x 130mm (5”) from the outer bowl

Tool posts fit both the irons tool gate, promount and the bowl saver so only one post is required

When ordering please state size of tool post.